Kim Leanne's ART

ARTIST & ART TEACHER

FREE   Art  lessons

click on the link for 4 simple steps to creating an

INSTANT WATER DROP

 using just black and white pastel pencils.

This lesson is an extract from the DVD series

"Welcome to My Garden"

GOANNA  in  charcoal

 

About the Goanna

This cheeky character turned up in my garden as I was shooting film for my new step-by-step painting dvd titled "Welcome to My Garden". I couldn't help but take some film and produce a portrait of him.

 

What you will need:

 · Drawing paper (I used 50cmx70cm 220gsm textured pastel paper in a Naples yellow colour)

· Charcoal ( I used a medium charcoal pencil and a stick of extra thick willow charcoal.

· Eraser (I used a Gum eraser )

· Graphite pencil, eraser and practice paper for your initial sketch .

· Tracing paper ( I used a roll of greaseproof lunch wrap)

· Dark pencil or biro for transferring onto your tracing paper.

· Light grey pastel for rubbing over the back of your tracing paper.

· Paper stump - optional (I just used my finger) 

 

 

 Firstly I cropped  the photo down to the centre of interest. I actually turned my photo and worked on a horizontal format. I did this to make the photos landscape format which fills out  your computer screen better, but I also found it more comfortable to work on the picture this way as I had my paper stuck to a wall to make it easier for photographing, and it was very good to be working at a constant height. 

 

step 1

 

I worked out my initial  drawing on some “scrap” (water damaged pastel paper), and transferred  the image to my “good” paper.  

If you are not familiar with this technique here are the steps:

1. Trace your outline onto tracing paper (or greaseproof lunch wrap) 

2. Rub on the back of the tracing with a light grey pastel.

3. Place your tracing pastel side down onto your good paper.

4. Redraw the outlines over your template.

Handy hint: to keep your tracing paper in place hold it down with a few small blobs of blue tack in the corners.  

 

step 2

I realize this image is very faint and you probably can’t see the details properly but in real life you can just make them out. This is what you  want on your own drawing. Just enough to see where you are going. 

 

step 3

 

I find it best with charcoal to work left to right to avoid smudging. If you are left handed you may find it easier to reverse the image to make life easier (or cleaner). The very first thing I did was the eye ball. I then gradually worked outwards.

For the eye , nostril and smaller details I worked with the charcoal pencil for the rest I used the extra thick stick of willow charcoal.  

Handy hint: if you can’t stand the feel of charcoal in your fingers like me just wrap a folded tissue around the stick . 

 

step 4

 

Add the stripes in with short jagged strokes working your way around the curves rather than drawing in the lines. If you draw in outlines for your stripes it is very difficult if not impossible to stop them from showing through the finished work.

 

step 5

 

 

I worked my way down to the shoulder and then concentrated on  the stripe pattern of the front leg.

Again, DON’T DRAW THE STRIPES HORIZONTALLY. Instead work in short jagged strokes vertically.

I use the pencil for the claws and finer shadow areas between the fingers, otherwise it is charcoal stick. 

 

step 6

 Move down the body working around the pale spots. Work mostly with short horizontal and vertical strokes to build up the dark areas. 

 

 

step 7

 Add on the back leg and tail and the body is complete. Now stand back and reassess the shading. 

 

 

step 8

 By gently dragging the charcoal across the textured paper you will gain shading with a nice “reptile” finish to it. For the darker areas where you don’t want any light paper showing through, press the charcoal into the paper by rubbing with your finger or a paper stump. (If you use your finger like I did you will need to wash it periodically to keep everything clean)

 

The longer you look at a picture the more details you will start to notice. I have added some more folds to the skin on the neck here. 

 

step 9

 

Moving onto the tree trunks. The trunk the goanna is holding is smooth new bark. To replicate this your shading edges need to be smooth and blended. Add the shading softly and  rub the charcoal into the paper with your finger or stump. 

step 10

 The trunk behind the goanna is also smooth bark but not quite a smooth as the thinner trunk. Allow your shading to be a little bolder on this one. .

 

 The bark on the final trunk is obviously much rougher than the other two. There is much more contrast in the shading here. I wanted the texture to show up  without competing with the goanna for attention. To achieve this I started the trunk the same way as the other two by shading and blending then added the darker strokes overtop.  

 

final step

 

To soften the effect but still maintain the rough look I then erased the highlights with an eraser, working in short strokes with the grain of the bark vertically and diagonally similar to the  charcoal strokes. I used a gum eraser for this. You will need to clean your eraser after every couple of strokes. A sheet of textured paper or fine sand paper is good for this.  

To add the leaves I turned the picture right way up. I found it easier to work this way as I was no longer referring so much to the photograph for placement. You will notice also that I have not drawn in the leaves as they were but strategically placed them to direct attention back to the main subject. 

You will notice if you refer back to the original photo that the goanna was actually well camouflaged . That’s fine when he wants to hide but for a portrait I wanted him to stand out.  

This is what Artistic Licence is all about.

 

 

If you would like to print this lesson:

visit my blog for a more printer friendly version at http://kimleanneart.blogspot.com/2010/03/charcoal-goanna.html

EASTERN YELLOW ROBIN in Watercolour

 

about the Yellow Robin

The Eastern Yellow Robin is one of my very favorite birds. It is so easy to film because of it's curious nature. Most days you can find one or more somewhere on my property and I have featured it in my painting lesson dvd "Welcome to My Garden". This particular photo was one of my references for the pastel lesson.

drawing steps

Follow these simple steps to produce your outline image. I prefer to work out my image on cheap drawing paper then transfer to the water colour paper.  This eliminates damaging the good paper with the constant erasures I seem to make. I  don't bother with details at this stage, the aim is to establish the positions of the main features.

step 1

Transfer your outline drawing to the watercolour paper by tracing  onto  tracing paper then rubbing the back of the image with the water-soluble graphite pencil. Place the template, graphite side down, in position on the watercolour paper and draw over the image with a biro or stylus. Keep a light touch so as not to engrave the image into the paper.

 

step 2

Using  a  4B and 2B water-soluble graphite pencil , shade the darkest areas. The colour spreads once it is wet and can be  quite strong  so I prefer to start cautiously. Although the graphite CAN still be erased after it has been wet it is still easier to darken than to lighten.

 

step 3

Using a wet no 8 sable round brush blend the graphite. Always consider the direction of the feathers and the shading  with your brushstrokes.

 

step 4

Let the piece completely dry then reinforce the darkest areas with the water-soluble graphite pencil. If any areas are too dark they can be lightened with a normal graphite eraser. Alternatively they can be wetted and lifted out with a tissue.

Ensure that the paper is DRY before using an eraser or you will damage it .

 

step 5

Blend again with  your damp paintbrush. Highlights can  be lifted out with a normal pencil eraser as I have done around the eyes and along the leg. Graphite can be erased from anywhere that you feel your picture has become too dark.

 

final step

Finally, add the yellow. Keep some variation in the tone. I have used cadmium yellow watercolour here, but watercolour pencil, soft pastel or coloured pencil would be just as effective. Watercolour cannot be removed with the eraser but can be lightened if necessary buy rewetting and lifting out with a tissue.

 

If you would like to print this lesson:

visit my blog for a more printer friendly version at:  SIMPLE DRAWING STEPS FOR EASTERN YELLOW ROBIN